Steampunk Wrist Braces

Finished and shipped out this set of steampunk bracers for there wrists. They are done out of a nice brown leather. It has a thumb hole, rests just below the knuckles and goes down the arm. There is a small dart in the leather to give them more shape. Lots of antiqued eyelets. The lacing is black and gold, actually done with crocheted cord. On the bottom side are slots with metal brace bits to keep the wrist sitting properly.

Leather Top Hat

My latest obsession that kept me from finishing other projects was the leather top hat. Excitingly enough, another project actually for me. I do manage to go for those sorts of projects every now and again.

I did a pattern out of poster board, based off of measurements and such. largely based off of me figuring it out as I want along, to be honest. Once that was reasonably what I was after, I pulled the mockup back apart and laid it out on my leather. I started with just plain old tooling leather.

With pieces cut out, I used wool daubers to swipe on the dye, which let me get a more mottled effect. Which is totally awesome. Once that had dried, I did a quick wet seal on it. Basically running it under the faucet to rinse out any excess dye, then dried everything again between paper towels.

That finished out, I played with options, and decided to put holes along the inside of the brim and the bottom edge of the main body first. Then I riveted the main body piece. I went with the double row of rivets for purely aesthetic reasons. Stitching or even a single row of rivets would have worked just as well.

To stitch the brim in place, I wet down the inside edge of it and then flared it up a little before stitching to get it to sit more how I wanted. From there, I could wet the brim itself and play with shaping until I found the brim shape I was after. Which I actually found rather quickly after first toying.

The top was originally going to have an amount of flare, but once I hit this point, I actually changed my mind and cut back the top piece and re-dyed the edges. I still had to stretch the top just a little to make things sit how I wanted, but the effect on the shaping is very subtle.

I actually stitched the top twice. Once while wet for stretching, then pulled it out and re-stitched to get it tight and perfect.

From there, I used a block out sealing layer. This didn't change the dye much, which is what I was after.

The hat band piece I also did myself. It currently isn't attached quite how I intend to really have it, but I have not finished the hat pin I want to do. By which I mean, I haven't quite figured out what exactly I want for it. For the time being, I am just using a pin to hold the hat band in place. I intend to keep it removable, so that I can swap in alternate hat bands easily if I ever want to change things up a little. Probably I will add some little hook catches for that purpose.

The band itself is some awesome fabric I found at a shop in Hawaii. (Yes, I went to a fabric store while on vacation on a tropical island.) I cut the strip and wrapped it around a semi-heavy bit of craft fuse stuff. I ironed it in place, then stitched the back edge by hand. I also folded over the one end and stitched that to give it a little nicer of an end piece.

And here are the photos.